Build quality seems subpar the exception of the connection between the cable and the pressure switch.

I noticed very shortly after installing the switch that if the cable was positioned just so, it would short and my light would turn on. So I moved the cable around, eventually pushing and pulling it slightly. Next thing I knew the wire came out of the switch and I was staring at the 2 end of the wire meant to be soldered to the switch PCB.


After opening it up for an autopsy (don’t recommend, the switch is held together by glue), I found that the only thing holding the wire to the switch were two extremely tiny solder points with not nearly enough solder.


If the solder points were improved and the cable anchored to the housing in some way, this would be a great buy